<

Setup Mikrotik routers with OSPF… Part 2

Posted on
7,404 Points
1,404 Views
Last Modified:
Experience Level: Beginner
5:16
Dirk Mare
Bio
I have 12+ years of experience in diagnosing and resolving technical/customer inquiries.
After creating this article, I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites.

This video is the second in a three-part series that shows you how to load the configuration… In this video I will continue with Router 3 and start with Router 2 config, after the config is loaded I will enable the OSPF networks and PPTP accounts for router 5,6 and 7, watch as OSPF dynamically update the IP route entries.

Please note typo
"Router 3 will only see.." should read "Router 2 will only.."
Apologies for this mistake..

Thank you for watching and reading my video/article, please leave valuable feedback. If you liked this video and would like to see more, please click the “Good Video button?”

I look forward to hearing from you.

DirkMare
0
Comment
Author:Dirk Mare
0 Comments

Featured Post

Powerful Yet Easy-to-Use Network Monitoring

Identify excessive bandwidth utilization or unexpected application traffic with SolarWinds Bandwidth Analyzer Pack.

Join & Write a Comment

This article is about building a VRF-Aware site to site VPN tunnels in Cisco CSR1000V router with IOS XE. There are two VRF-Aware Policy Based IPsec VPN tunnels configured on CSR1000V router one with NAT and another without NAT.
This article is about building a Route Based site to site VPN tunnels with dynamic routing protocol (OSPF) in Cisco CSR1000V router with IOS XE. There are two Route Based IPsec VPN tunnels configured on CSR1000V router, traffic from app server is w…
Total Time: 16:02

Keep in touch with Experts Exchange

Tech news and trends delivered to your inbox every month