<

Setup Mikrotik routers with OSPF… Part 3

Posted on
6,683 Points
683 Views
Last Modified:
Published
Experience Level: Beginner
5:32
Dirk Mare
Bio
I have 12+ years of experience in diagnosing and resolving technical/customer inquiries.
After creating this article, I decided to make a video (no audio) to show you how to configure the routers and run some trace routes and pings between the 7 sites.

This is the final video in the series that shows you how to load the configuration… In this video I will continue with Router 7 and Router 4 testing and start with Router 1 config, after the config is loaded I will enable the OSPF networks and PPTP accounts for router 5,6 and 7, watch as OSPF dynamically updates the IP route entries.

Thank you for watching and reading my video/article, please leave valuable feedback. If you liked this video and would like to see more, please click the “Good Video button?”

I look forward to hearing from you.

DirkMare

Video Steps

1. Steps can be found in the article link above.


Please visit my article in the description above to get the code and more info about this video micro tutorial.
0
Author:Dirk Mare
0 Comments
Assume that as a role of System Administrator in SMB (or a startup group), you are requested to (re)design the IT infrastructure of the company. In this article, I will describe the steps of design, configure and operate the IT devices in a small bu…
This article is about building a Route Based site to site VPN tunnels with VRF and dynamic routing protocol (OSPF) in Cisco CSR1000V router with IOS XE. There are two Route Based IPsec VPN tunnels configured on CSR1000V router, traffic from app serv…
Total Time: 16:08

Keep in touch with Experts Exchange

Tech news and trends delivered to your inbox every month